Atas Dutch Seam Bedienungsanleitung PDF herunterladen

Installation Guide

The Dutch Seam roof panel, with integral seam, is available in

three widths with seam spacing of 11”, 15”, and 19-1/4” o.c.

The panels are roll-formed from 16 oz. copper, .032 and .040

aluminum and 24 ga. Metallic Coated steel, smooth or stucco

embossed, with or without stiffening ribs. 22 ga. Metallic

Coatedsteel is available, subject to minimum quantity. The

material has a KYNAR 500

or HYLAR 5000

quality finish,

in 30 standard colors. The minimum panel length is 2’-0”, the

maximum is determined by shipping considerations. Minimum

recommended pitch is 2:12 depending upon geographical

location and/or roof geometry..

19-1/4” (Nom.)

15” (Nom.)

11” (Nom.)

1-1/2”

MRD194

MRD150

MRD110

1” 1”

13/16”

3”

1/4”

1” 1”

3”

5/8”

1/16”

“RAISED” ANCHOR CLIPS

MRS901 - 24 ga. galvanized steel

MRS991 - 22 ga. stainless steel

NOTE: When utilizing the raised clip, all roof edge areas (ridges, val-

leys, eaves, gables, etc.) must be shimmed 1/4” so trim pieces are on

the same plane as the panels. The raised clips allows for use of hex

head type fastners.

“FLAT” ANCHOR CLIPS

MRS903 - 22 ga. stainless steel

MRS904 - 24 ga. galvanized steel

Clips designed for use with wafer (pancake) headed screws.

Review and understand complete guide

before beginning installation.

This guide has been prepared as suggested

details to particular design conditions.

Each condition has certain limitations to performance,

aethetics or economics. Professionals qualified to assess

this information for a specific project, should determine

that the selection and installation are made to their

requirements. ATAS cannot assume any responsibility for

the actual selection and/or installation of materials. The

panels, flashings and trim shown in this guide are

illustrated over solid and plumb substrate. It is assumed

that the structure has been designed and prepared in

accordance with local building codes.

Published panel width dimensions are to be considered as nominal

dimensions. Variations in overall coverage may occur at installation due to

typical manipulating of panels during attachment to the roof assembly.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Installation Guide

Installation GuideThe Dutch Seam roof panel, with integral seam, is available inthree widths with seam spacing of 11”, 15”, and 19-1/4” o.c. The panel

Seite 2 - Valley Detail

Eave DetailGable DetailValley Detail1. In re-roofing applications: cut back and remove existing shingles and drip edge to be flush with the eave and g

Seite 3 - Shed Ridge Detail

Hip & Ridge DetailHeadwall DetailShed Ridge DetailHip and ridge applications are handled in the samemanner.1. Cut “Z” closure to fit between seams

Seite 4 - Sidewall Detail

Pipe DetailStep 1Cut on the proper pipe diametermarked on the flashing. Step 2Position over pipe and slidedown the pipe.Step 3Apply polyurethane seala