Atas CastleTop Bedienungsanleitung PDF herunterladen

Up-turned edge

Alignment mark

Alignment Point

Alignment

Point

Locking Tab

Down-turned Edge

Pre-Punched

fastening holes

Locking Tab

Connecting Area

15-3/4”

Expanded

Polystyrene

Backer Board

Shingle Layout

It is recommended to apply

waterproof membrane, such as

ATA-Shield**, at eave, gable, and

valley. Place ATA-Guard*

underlayment up from the eave.

For re-roof applications, remove

the extended roof material and old

drip edge. After Starter Trim is

installed (see page 2), snap a

horizontal chalk line at 8 ⁄” from

the edge after squaring up eave.

Snap vertical lines at 11 ⁄” o.c.

Line-up shingle corners with chalk

lines to assure square alignment of

the shingles. To aid in squaring of

shingle, make sure alignment

points meet at the alignment mark

of the lower course. Shingles are

secured with three fasteners per

shingle.

Helpful hint: to square-up the

shingle, line up the top hole with the

vertical line.

Installation Guide

Review and understand

complete guide before

beginning installation.

This guide has been prepared

as suggested details to

particular design conditions.

Each condition has certain

limitations to performance, aesthetics

or economics. Professionals qualified to assess the

information regarding suitability for a specific project

should determine that the selection and installation

are made to their requirements. ATAS cannot assume

any responsibility for the actual selection and/or

installation of materials. The panels, flashings and trim

shown in this guide, illustrated over solid and plumb

substrate, assume that the structure has been

designed and prepared in accordance with local

building codes.

CastleTop is a diamond shaped at metal shingle. These shingles have a unique

locking feature that allow for easy installation. The overlapping shingles have a

turned down edge on the lower front and a turned up edge on the upper front.

The panel is 15 ¾” square, net coverage is 13 ⁄” x 13 ⁄”. There are approximately

78 shingles per 100 square feet. The CastleTop shingle is packed 39 shingles

per carton, which equates to approximately half of a square.

Valley @

Dormer Area

Eave Line

8-3/8”

22-1/4”

Strike square horizontal chalk line

at shingle course as a “benchmark”

to work at opposite side of valley.

Horizontal chalk line

for first course

Published panel width dimensions are to be considered as nominal dimensions. Overall panel

width dimensions may vary during installation due to adjustments to accommodate as built roof

conditions.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Installation Guide

Up-turned edgeAlignment markAlignment Point Alignment Point Locking TabDown-turned EdgePre-Punched fastening holesLocking Tab Connecting Area15-3/4”Ex

Seite 2 - Valley Detail

Eave DetailGable DetailValley Detail1. When applying in a re-roof application, cut back existing shingles and drip edge to be flush with the eave and

Seite 3 - Shed Ridge Detail

Hip & Ridge DetailHeadwall DetailShed Ridge DetailHip and ridge applications are handled in the same manner.1. Install Castle Top roof shingles to

Seite 4 - Sidewall Detail

Step 1Cut on the proper pipe diameter marked on the flashing. Pipe DetailStep 2Position over pipe and slide down the pipe.Step 3Apply polyurethane sea